Buick Skylark P0773 Engine Error Code
When you check Buick Skylark car engine light came on code P0773 the reason should be Engine Light ON (or Service Engine Soon Warning Light). However Buick manufacturer may have a different definition for the P0773 OBD-II Diagnostic Powertrain (P) Trouble Code. So you should chech it on our car models.
![P0773 Buick Skylark Code Clear](https://engineerrorcode.com/images/clear-engine-codes.jpg)
Another consequence of P0773 Buick Skylark engine overheating may be a blown head gasket. Heat makes aluminum swell almost three times faster than cast iron. Thermal stress can distort the head and make it swell in areas that are hottest like those between exhaust valves in adjoining cylinders, and areas that have restricted coolant flow like the narrow area that separates the cylinders. The typical aluminum head swells most in the middle, which can crush the head gasket if the head gets too hot. This will usually cause the head gasket to leak compression between adjacent cylinders, or leak coolant into the cylinders.
![]() |
Buick Skylark P0773 OBD-II Diagnostic Powertrain (P) Trouble Code DescriptionBuick Skylark car P0773 OBD-II Trouble Code Shift solenoid valve E is turned ON or OFF by the Transmission Control Module (TCM) in response to signals sent from the park/neutral position (PNP) switch, vehicle speed and Engine Control Module (Reason For Buick Skylark P0773 CodeThe reason of Buick Skylark P0773 OBD-II Engine Error Code is P0773 Shift Solenoid E Electrical. |
If your P0773 Buick Skylark check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system and engine control unit are in charge of monitoring a bunch of different P0773 Buick Skylark, and if they get a reading that's a little out of whack, up pops the check engine light.
Buick Skylark P0773 Possible Solution :
Power Steering Pressure (PSP) Switch Signal Malfunction The PCM counts the number of times vehicle speed transitions from 0 to a calibratable speed. After a calibratable number of speed transitions the PCM expects that the PSP input should have changed. This DTC is set if the transition is not detected. Vehicle towed with engine running Power steering hydraulic concern was repaired but DTC was not erased PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged Check, if possible, if vehicle was towed or power steering service was performed. Observe PSP V PID while checking wires for intermittents.
What does fault code P0773 mean for Buick Skylark ?
|